Hose adapter 15.9 mm to 12.7 mm (5/8 to 1/2 inch) with barbs
A reducer that joins two hoses or pipes of different sizes, with optional barbs to grip the hose.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Large end outside diameter | 15.9 mm |
|---|
| Small end outside diameter | 12.7 mm |
|---|
| Wall | 1.6 mm |
|---|
| Large end length | 14 mm |
|---|
| Small end length | 14 mm |
|---|
| Barbs per end | 3 |
|---|
Checked by our engine
- One closed solid, measured 17.8 × 17.8 × 33 mm
- Thinnest wall 1.6 mm
- Some surfaces overhang more than 45° as the file is oriented; they may need supports or a different orientation.
- About 3 g of PLA if printed solid (less with normal infill)
Printing notes
- Print standing up with no supports.
- Use PETG or ASA for water or outdoor use. Printed adapters are not for pressurised lines.
- Add a hose clamp on each end for a tight seal.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.