Spur gear, module 2, 12 teeth
A standard involute spur gear (20° pressure angle) with a round bore. Gears with the same module mesh.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Module | 2 mm |
|---|
| Teeth | 12 |
|---|
| Thickness | 10 mm |
|---|
| Bore | 8 mm |
|---|
Checked by our engine
- One closed solid, measured 28 × 28 × 10 mm
- Thinnest wall 3 mm
- About 5 g of PLA if printed solid (less with normal infill)
Printing notes
- Two gears mesh when their centres are module x (teeth of gear 1 + teeth of gear 2) / 2 apart.
- Print flat. Nylon or PETG wear better than PLA for gears that run often.
- The bore is a plain hole; add a set screw or a press fit as your shaft needs.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.