Spur gear, module 1, 12 teeth
A standard involute spur gear (20° pressure angle) with a round bore. Gears with the same module mesh.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Module | 1 mm |
|---|
| Teeth | 12 |
|---|
| Thickness | 5 mm |
|---|
| Bore | 4.2 mm |
|---|
Checked by our engine
- One closed solid, measured 14 × 14 × 5 mm
- Thinnest wall 1.5 mm
- About 1 g of PLA if printed solid (less with normal infill)
Printing notes
- Two gears mesh when their centres are module x (teeth of gear 1 + teeth of gear 2) / 2 apart.
- Print flat. Nylon or PETG wear better than PLA for gears that run often.
- The bore is a plain hole; add a set screw or a press fit as your shaft needs.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.