Spur gear, module 0.8, 60 teeth
A standard involute spur gear (20° pressure angle) with a round bore. Gears with the same module mesh.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Module | 0.8 mm |
|---|
| Teeth | 60 |
|---|
| Thickness | 4 mm |
|---|
| Bore | 3 mm |
|---|
Checked by our engine
- One closed solid, measured 49.6 × 49.6 × 4 mm
- Thinnest wall 1.6 mm
- About 9 g of PLA if printed solid (less with normal infill)
Printing notes
- Two gears mesh when their centres are module x (teeth of gear 1 + teeth of gear 2) / 2 apart.
- Print flat. Nylon or PETG wear better than PLA for gears that run often.
- The bore is a plain hole; add a set screw or a press fit as your shaft needs.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.