Project box 40 x 40 x 20 mm inside, snap-on lid
A box with a snap-on lid for small electronics or parts, sized by its inside dimensions.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Inside length | 40 mm |
|---|
| Inside width | 40 mm |
|---|
| Inside height | 20 mm |
|---|
| Wall | 2 mm |
|---|
| Corner radius | 3 mm |
|---|
Checked by our engine
- Base: one closed solid, measured 44 × 44 × 22 mm
- Lid: one closed solid, measured 44 × 44 × 6 mm
- Thinnest wall (base) 1.3 mm
- Thinnest wall (lid) 1 mm
- About 19 g of PLA if printed solid (less with normal infill)
Printing notes
- Print the base open side up and the lid with its flat face on the bed.
- The lid snaps on with a 0.4 mm ridge; if it is too tight, sand the ridge lightly.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.