Pipe clamp for a 50 mm pipe
A saddle clamp that holds a pipe or rod against a wall with two screws.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Pipe diameter | 50 mm |
|---|
| Wall | 3 mm |
|---|
| Width | 18 mm |
|---|
| Tab length | 12 mm |
|---|
| Tab thickness | 3 mm |
|---|
| Screw hole | 5.5 mm |
|---|
Checked by our engine
- One closed solid, measured 80.4 × 18 × 28.2 mm
- Thinnest wall 3 mm
- Some surfaces overhang more than 45° as the file is oriented; they may need supports or a different orientation.
- About 7 g of PLA if printed solid (less with normal infill)
Printing notes
- Print with the tabs on the bed.
- The clamp leaves 0.4 mm of play around the pipe; it holds, but does not grip tightly.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.