L bracket 60 x 30 mm, 25 mm wide, for M4 screws
A right-angle bracket with countersunk screw holes in both legs and a rounded inside corner for strength.
Other sizes and the STEP file use 1 credit, once for this part.
Dimensions
| Base leg length | 60 mm |
|---|
| Upright leg height | 30 mm |
|---|
| Width | 25 mm |
|---|
| Thickness | 5 mm |
|---|
| Screw hole | 4.5 mm |
|---|
| Countersink diameter | 9 mm |
|---|
| Holes per leg | 1 |
|---|
Checked by our engine
- One closed solid, measured 60 × 25 × 30 mm
- Thinnest wall 5 mm
- About 13 g of PLA if printed solid (less with normal infill)
Printing notes
- For strength, turn the part onto its side in your slicer so the layers run around the bend. Printed as it opens, the corner is held only by layer adhesion.
- Holes are sized for ISO countersunk screws with a medium clearance fit (for example 4.5 mm for M4).
- PETG or ABS/ASA hold their shape better than PLA under a constant load or in heat.
Every part is a starting point. Check every dimension before printing or manufacturing. We make no promise about strength or load.